For configuring SNMP agents in Cisco devices, you need to log into the device and switch to privileged mode.
Use the following set of commands listed below to enable SNMP:
To enable SNMP:
From the command prompt, run the following commands:
#configure terminal
#snmp-server community <community_string> rw/ro (example: snmp-server community public ro)
#end
#copy running-config startup-config
To enable trap:
Again, from the command prompt, run the following commands:
#configure terminal
#snmp-server enable traps snmp authentication
#end
#copy running-config startup-config
To set OpManager as host:
Run the following commands from the command prompt:
#configure terminal
#snmp-server host < OpManager server running system's IP> <Trap community string> snmp (example: snmp-server host 192.168.9.58 public snmp)
#end
#copy running-config startup-config
For more information, visit CISCO.