Support
 
Phone Get Quote
 
Support
 
US: +1 888 720 9500
US: +1 888 791 1189
Intl: +1 925 924 9500
Aus: +1 800 631 268
UK: 0800 028 6590
CN: +86 400 660 8680

Direct Inward Dialing: +1 408 916 9892

ADAudit Plus » QNAP NAS Auditing Guide » Configure QNAP NAS Auditing
Download PDF
 

Configuring QNAP NAS auditing

This page describes the steps to configure your target QNAP network attached storage (NAS) device to send audit logs and add a QNAP NAS server to the ADAudit Plus console.

Configuring log settings and forwarding

To set up communication between ADAudit Plus and the target QNAP NAS server and to enable log forwarding, follow these steps:

  • In the QuLog Center, navigate to Local device > Log Settings > Access Log Settings.
  • Under Connection Types, select SMB (Windows) and click Apply.
  • Then, navigate to QuLog Service > Log Sender. Enable Send logs to a remote QuLog Center.
  • Click Add Destination. In the resulting pop-up, enter the following details:
    • The IP address of the machine where ADAudit Plus is installed.
    • The preferred port number, 514 by default.
    • The transfer protocol, UDP.
    • Select Access Log as the Log type.
  • Click Apply.

Adding QNAP NAS servers

To add your target servers to the ADAudit Plus console for auditing, follow these steps:

  • Log in to the ADAudit Plus web console with admin credentials.
  • Navigate to the tab File Audit > Configured Server(s) > QNAP NAS and click Add Server in the top-right corner.
  • In the Add QNAP Server pop-up, enter the name of the target server. Click Next.
  • Select the shares you wish to audit and click Next.
  • Review your selection and click OK.

ADAudit Plus Trusted By

Meet all auditing and IT security needs with ADAudit Plus.

  • Active Directory
  • File servers
  • Windows server
  • Workstation
  • Compliance
  • Related Products

A single pane of glass for complete Active Directory Auditing and Reporting

Free Trial Get Quote