# Endpoint Central Server Not Reachable! Last Updated On: 28 Oct 2026 4 minutes read ## Problem You have problems in reaching the Endpoint Central server or Distribution Server, and you run the "Agent Diagnostic Tool". You get an Error "Server Not Reachable!", during the process. ## Cause You will encounter this error due to one or more of the following reasons: 1. Endpoint Central Server/Distribution Server has been Stopped 2. Endpoint Central Server/Distribution Server has been configured with a new IP address 3. Endpoint Central Server/Distribution Server has been migrated 4. Computer on which Endpoint Central Server/Distribution Server has been installed has been shutdown 5. Ports blocked on the firewall of the Endpoint Central Server/Distribution Server 6. Newly added agents cannot contact the server if the license limit has already reached. ## Resolution You need to verify the following the steps mentioned below: 1. Open command prompt and type "**tracert**" followed by server's IP address. For Example: **tracert 101.104.12.104** 2. The TRACERT diagnostic utility determines the route taken to a destination by sending Internet Control Message Protocol (ICMP) echo packets with varying IP Time-To-Live (TTL) values to the destination. The TRACERT command can be used to determine where a packet stopped on the network. In the following example, the default gateway has determined that there is not a valid path for the host on 22.110.0.1. There is probably a router configuration problem or the 22.110.0.0 network does not exist (a bad IP address). Example: **C:>tracert 22.110.0.1 Tracing route to 22.110.0.1 over a maximum of 30 hops 1 157.54.48.1 reports: Destination net unreachable. Trace complete.** 3. Ping the server ip (ip:port) using browser and see if it gets connected. You can open the Central server console from agent machine to check the connectivity. 4. **Telnet** the central server from the agent installed device. To telnet, open the command prompt and run the command `telnet ` in administrator mode. 5. If you still can not reach the Endpoint Central server, then verify the port numbers that need to be open on the Endpoint Central firewall. **Note:** If a proxy connection is enabled between agents and server, disable the connection to check the connectivity. To collect diagnostic details from the agent machine, run the [Agent Troubleshooting Tool](https://www.manageengine.com/products/desktop-central/help/device-onboarding/agent-troubleshooting-tool.html) from the agent tray icon or at **\bin\agent_troubleshooting_tool.exe**, and use its **Export** option to generate the report for the support team.