Policy Parameters

    Policy Parameters are the reusable values that control policy conditions refer to, such as a set of office IP addresses, a block of working hours, or a pattern that identifies sensitive data. You define each value once under the Control Policy page and then select it while building a policy.

    Steps to create an IP address category

    1. Go to Access Protection > Access Controls > Control Policy.
    2. Click Policy Parameters.
    3. In Parameter Type, select IP Address Category.
    4. Click + Add IP Address Category.
    5. Enter the Category Name.
    6. In IP Address Ranges, enter the start and end address of a range. Use the add icon to add more ranges.
    7. In Individual IPs, enter single addresses separated by commas.
    8. To add an optional description, click Description and enter it.
    9. Click Save, then click Close.

    Steps to create a time category

    1. Go to Access Protection > Gateway > Control Policy.
    2. Click Policy Parameters.
    3. In Parameter Type, select Time Category.
    4. Click + Add Time Category.
    5. Enter the Category Name.
    6. Select the Days the category covers.
    7. Set the Start Time and the End Time.
    8. To add an optional description, click Description and enter it.
    9. Click Save, then click Close.

    Steps to create a regex pattern

    1. Go to Access Protection > Gateway > Control Policy.
    2. Click Policy Parameters.
    3. In Parameter Type, select DLP Patterns. The Built-In Patterns and Custom Regex Patterns tabs are displayed.
    4. Open the Built-In Patterns tab, which lists the patterns SecureAI provides. Select a Country and a Compliance to view them.
    5. Open the Custom Regex Patterns tab and click Create Regex Pattern.
    6. Enter the Pattern Name and the Regex Pattern.
    7. To add an optional description, click Description and enter it.
    8. Click Save, then click Close.