How to apply the 8051 service pack on ADManager Plus build 8050

Last updated on:

In this page

Objective

If you are upgrading ADManager Plus from build 8050 to 8051, run this pre-check when the Update Manager opens but does not proceed after you browse to the 8051 service pack (.ppm) file. The pre-check updates updateManager.bat, a file the Update Manager uses, so that the Update Manager can install the 8051 service pack.

Note: If you are on any other build other than 8050, or if the 8051 service pack applies normally, skip this pre-check and apply build 8051 directly.

Before you begin, confirm the current build, download the build 8051 service pack, and follow the standard backup prerequisites. If high availability or load balancing is enabled, use the deployment-specific upgrade instructions.

Steps to follow

Follow these steps to run the pre-check and then apply the 8051 service pack:

  1. Download UpdateManager_8051_PreCheck.zip.
  2. Extract the ZIP file. It contains the following files:
    • UpdateManager_8051_PreCheck.jar
    • Run_8051_PreCheck.bat
  3. Stop ADManager Plus.
  4. Copy both extracted files to <admanagerplus_install_dir>\bin. The default location is C:\Program Files\ManageEngine\ADManager Plus\bin.
  5. Open Command Prompt as administrator and run the following two commands, one after the other:

    cd /d "<install_dir>\bin"
    updatePatchManagerBat.bat

  6. Check the message shown in Command Prompt and continue based on it:
    • If you see "Pre-check completed successfully. You can now apply the 8051 service pack.", the file is updated. Go to step 7.
    • If you see "Pre-check already completed. No changes needed. You can apply the 8051 service pack.", the file was updated earlier. Go to step 7.
    • If you see "This pre-check is required only for build 8050. Your build is <build_number>. You can apply the 8051 service pack directly.", your build does not need the pre-check. Go to step 7.
    • If you see any other message, stop here and do not apply the service pack. Contact ADManager Plus support and share a screenshot of the Command Prompt output.
  7. To apply the 8051 service pack, run <admanagerplus_install_dir>\bin\UpdateManager.bat, browse to the 8051 service pack (.ppm) file, and install it.
  8. After the service pack installs successfully, start ADManager Plus using the method appropriate to your application or Windows service deployment. Verify that the displayed build number is 8051.
Note:
  • You need to run this pre-check only once. Running it again makes no further changes.
  • A backup of the original PatchManager.bat file is saved in <admanagerplus_install_dir>\bin as PatchManager.bat_8050_backup
  • No product data or settings are changed.

ADManager Plus is now upgraded to build 8051. If the issue continues, contact ADManager Plus support.